Once you start thinking outside the box, it's easy to make a unique soap mold with everyday items. When fun and cheap alternatives are readily available, there is absolutely no need to buy professional soap making molds.
One of my favorite ideas for creating a unique soap mold is to use a PVC tube to form a round soap. Not only does it create a beautifully finished product, but the soap-forming method is also very simple to put into practice.
Creating a PVC soap mold requires 5 pieces of equipment, including: PVC pipe, cutting board, funnel, ladle and frozen paper.
So what are the steps? When you are ready to pour the initial soap into the mold, place the PVC tube vertically at the end of the cutting board. Make sure all edges are firmly against the wood and are fixed there with considerable force. After all, you don't want soap to flow from the bottom!
Now place the funnel in the pipe opening to facilitate pouring. Never use a funnel made of silicon or stainless steel, as this early soap can be very corrosive and irritating. Never use any form of plastic equipment. Once the soap has time to cure, the pH will change dramatically, resulting in a mild skin cleanser, but for now, you need to be a little careful.
Next, use a ladle to start transferring the soap from the pan to the PVC pipe. Again, you need to make sure that the bucket is also made of the right material. Never fill the PVC pipe all the way to the edge as the soap will swell during the curing process. I personally recommend that you leave about 3 inches at the top.
Cover the open area of the PVC pipe with frozen paper and secure it in place with a rubber band. This helps keep heat in the mold.
It's time to further isolate your soap. Take an old blanket or a large towel, you don't mind destroying and completely wrapping the outside of the mold. Be as free as possible. I recommend using about 7-10 towels or 4 blankets. It is important that the heat caused by the soap making reaction dissipates as slowly as possible in order for proper curing to occur.
Patience is critical for cold-processed soap manufacturers because you must wait about 72 hours to harden the soap. Keep in mind that once it's hard, it's still too corrosive because it's not completely cured.
The soap is slipped out of the PVC tube and cut into strips of approximately uniform width. If you find it difficult to remove soap from this unique soap mold, you can use a can to push it out or put the soap in the refrigerator to shrink it.
Place the new rod on the shelf to cure and let the air circulate around it. Be sure to flip every few days. After 6 to 8 weeks, you are ready to test the pH and use the brand new all-natural skin care products!
Orignal From: Making unique soap molds from PVC pipes
No comments:
Post a Comment